Aeware in.xm2 Spa Control System Complete with in.k600 touchpad & remote in.therm heater with in.touch module
REMOTE ACCESS WITH iPHONE, iPOD, iPAD via wi-fi for full spa control from anywhere Universal spa control system - 1 - 5 pumps, circulation pump, blower, ozone and light - many combinations possible (normally 3 pumps, blower, ozone, light, with/without circulation pump) Aeware in.xm2 by Gecko Electronics 9 outputs - can accomodate a combination of the following - 1 - 5* pumps (up to 3 without optional in.split adaptor cables), blower, circ pump, ozone, light, aux/audio 3.8kw titanium in.therm in-line heater 15" long x 2" plastic tube, complete with unions. Utilises in.link cables to connect to equipment - Pump 1, Pump 2, Pump 3, Blower, Ozone & Light INCLUDED.Circulation Pump & Direct AV in.link cables extra if required. All inputs and outputs are plugged into the front panel. Incoming power supply is from the left side only through a 32mm hole (32mm gland/conduit fitting and appropriate cable set up required to maintain box seal against entry of vermin, ants, etc.) in.k600 11 button topside INCLUDED. 230v, 50Hz, 40A max single phase (can be configured for 15A), or 415v, 50Hz, 20A two or three phase. Pack 450mm wide x 260mm high x 80mm deep. Heater tube including unions 450mm long x 100mm wide x 110mm high Touchpad 220mm long x 106mm wide. 180mm long x 95mm wide * maximum number of pumps is restricted by pump size. Each outlet socket is limited to 16A (ie pump 1 and 4 could be 8A ea) but also restricted by spa pack max loading of 40A. If 4-5 high powered pumps require control, use aeware in.xe 'swimpa' system. *For the in.touch / iPhone setup to work, the spa must be within range of the 'i' device or home wifi network. If signal strength is poor an economical wifi 'range extender' could be purchased under $100 to ensure reliable performance.